|
A & D Astra Models 400
& 600 Pistols (steps 4-5)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Astra
400/600 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
Remove the 4 grip screws (43) and
the grips (21 & 42). Replace magazine (30) in frame. Insert
punch through hole in frame below trigger bar (35). Hold hammer
(13) with thumb and pull trigger, allowing hammer to fall until
upper plunger (27) stops against punch. Remove magazine. Drift
out hammer pin (20) from left side and remove hammer. Hold upper
plunger with drift and remove punch. Remove upper and lower
plungers (27 & 29) and hammer spring (28).( Model 600 has no
lower plunger.)
|
|
|
|
|
|
5.
|
|
Most Model 400 pistols have magazine
catch as shown here. Remove magazine catch stop (26). Drift out
grip safety pin (25), remove grip safety (22), and push out
magazine catch (24) in direction indicated. It is unnecessary to
remove side magazine catch on late Models 400 and 600 pistols.
|
|
|
|
|
|
|
|
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
