|
A & D Astra Models 400
& 600 Pistols (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Astra
400/600 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
0.
|
|
Note: mechanically, the
Models 400 and 600 are similar. The Model 600 is 3/4"
shorter. The front-to-back grip depth is less in the Model 600
because of the shorter cartridge it fires. Most parts are not
interchangeable but the takedown sequence is similar.
|
|
|
|
|
|
1.
|
|
To field strip for general cleaning,
first clear chamber and remove magazine (30). Pull slide (4) to
rear, then rotate safety catch(38) up as slide is moved forward
until catch engages slide. Rotate barrel (12) as shown, until it
is released from frame (31) and engaged with slide. Release
safety catch and move barrel and slide forward off frame.
|
|
|
|
|
|
2.
|
|
To disassemble, first clear chamber
and remove magazine. Place pistol, muzzle up, on table. Depress
barrel bushing (2) with magazine floor plate or screwdriver.
Turn barrel bushing lock (1) either way until it holds barrel
bushing. Grip barrel bushing and lock firmly with both hands and
turn lock 1/4 turn, releasing recoil spring (3). Remove recoil
sprig, bushing, and lock. Barrel and slide are removed from
frame as in field stripping.
|
|
|
|
|
|
3.
|
|
L-shaped retainer pins ( 7 & 8 )
retain the extractor (5) and the firing pin extension (11).
Remove pins by prying up with a small screwdriver or punch. When
reassembling firing pin spring (9), firing pin (10), and firing
pin extension before inserting the retainer pin (7).
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
