|
1.
|
|
To field strip the Bergman, first remove magazine and clear
chamber. Pull
down takedown latch (43) at front of trigger guard. Pull slide to rear as far as it will
go and lift it free of frame. Slide (1) can now be run forward off barrel.
|
|
|
|
|
|
2.
|
|
Safety catch (10) must be removed to get at firing pin (9). Loosen detent
retainer screw (11) and carefully remove detent components. Hold firing pin housing (7)
and firing pin forward and free of seat in safety catch, and push up safety catch.
|
|
|
|
|
|
3.
|
|
Last coil of recoil spring (27) fits barrel very snugly and must be
pushed free as shown, When replacing spring, be sure large end protrudes off barrel; otherwise
gun cannot be reassembled.
|
|
|
|
|
|
4.
|
|
Magazine catch (34) hooks over a cress pin in frame and must be pushed
back and lifted up fro removal. Use a screwdriver to ease it free and
to prevent hammer
spring (33) from throwing catch. Remove hammer sprig and strut (31)
|
|
|
|
|
|
5.
|
|
Trigger (23) houses 2 springs - trigger spring (26) and pin retainer
spring (22). When reassembling gun, use slave pins to hold springs in place. Slave pins
should be only as wide as trigger, and are pushed out when parts are pushed in.
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
| Page and
Contents © Marstar Canada Inc.
|
