|
Bernadelli
Model 60 Pistol (steps 4-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Bernadelli
model 60 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
Drift out the sear pin (23) and lift out the sear (8). Push the safety
spring (28) downward and remove through the underside of the frame. Center the sear spring
(7) in the frame with a screwdriver blade, and push upward to remove. Drift out the
trigger pin (20), roll the bottom of the trigger forward, and remove through the side of
the trigger guard.
|
|
|
|
|
|
5.
|
|
During reassembly, replace the trigger and trigger pin, and install the sear
spring through the top of the frame. Align the spring vertically, and lever it
horizontally against the left side of the frame. Insert the tail of the sear between the
sear spring and frame backstop, and replace the sear pin. Install the safety spring from
below, sliding it upward against the right side of the frame and behind the sear. Flex the
safety spring with padded long nose pliers when installing the safety. Inset shows proper
location of springs in the frame. All seat upon the fixed frame pin (A), which is never
removed.
|
|
|
|
|
|
6.
|
|
Safety must be disengaged to install the breechblock. Depress the trigger
and start the breechblock assembly into the frame until resistance is felt, then release
the trigger and push the breechblock fully home. Again depress the trigger and pull
forward on the recoil spring to release the firing pin from the sear. Grasp the rear of
the recoil spring tightly and pull forward over the recoil spring guide (3), until the
assembly can be swung down within the frame fork.
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
| Page and
Contents © Marstar Canada Inc.
|
