|
Bernadelli
Model 60 Pistol (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Bernadelli
model 60 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
Push the magazine catch (25) forward and remove the safety (19). Draw the
slide (4) fully to the rear and check visually that the chamber is empty. Release the
slide and pull the trigger. Unscrew and remove the breechblock screws (5) (6), and move
the slide forward off the frame (26). Lift the forward end of the recoil spring (1)
until it snaps free of the frame. Withdraw the breechblock (11) to the rear. This is
sufficient disassembly for normal cleaning. Disassemble further only as required.
|
|
|
|
|
|
2.
|
|
Insert a narrow screwdriver blade beneath the hook of the extractor (14).
Push the extractor outward until its lug clears the side of the breechblock. Then, pry the
extractor forward, bringing its wings into alignment with the disassembly hole. Drift out
the cocking lever pin (27), and remove the recoil spring mechanism. Drift out the
breechblock plug pin (30) to release the breechblock plug (32) and firing pin (31).
|
|
|
|
|
|
3.
|
|
To release the grips (10) (16), first loosen the grip screws (15) and turn
the grip retainers (17) from horizontal to vertical with a screwdriver inserted through
the bottom of the magazine will. Drift out the magazine catch pin (24),
and remove the
magazine catch (25) and trigger bar spring (29). Pull the forward end of the trigger bar
(22) downward into the magazine will amd remove. Move the safety midway between safe and
fire positions and push out with a punch.
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
| Page and
Contents © Marstar Canada Inc.
|
|
|
