|
Browning
High Power (steps 1-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Browning
High Power exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
1.
|
|
Remove the magazine. Pull back the slide and push the safety catch into
the second notch. Push out the slide stop (T-see 'exploded drawing') from right to left,
as shown. Release the safety catch and permit the slide to go forward and off the receiver
runners.
|
|
|
|
|
|
2.
|
|
Push the safety catch down to fire position, then push sear pin
(JJ) out
from right to left. Allow the ejector (FF) to pivot down until it stops. With the ejector
in this position, the safety catch (KK) can now be pushed out.
|
|
|
|
|
|
3.
|
|
Hold the gun in the left hand and push in the magazine catch (I) until it
is flush with frame. Using a 1/8 inch wide screwdriver, turn the magazine catch spring
guide to the magazine catch. Then lift out the unit.
|
|
|
|
|
|
4.
|
|
Push trigger pin (GG) out from right to left. Hold the gun with the right
side up. With the right hand, pull the trigger forward and upward; this will remove parts
(U), (HH), (II), and (OO) as a unit. These parts must be replaced as a unit when
reassembling the gun.
|
|
|
|
|
|
5.
|
|
To remove firing pin (F) and spring (E), hold the slide in the left hand.
With a 1/8 inch punch, push in the end of the firing pin; at the same time, push down on
the firing pin retainer plate (DD). After firing pin and spring have been removed, pry out
extractor (D).
|
|
|
|
|
|
6.
|
|
To remove the sear lever (CC), hold the slide upside down in the right
hand. Using a small screwdriver, pry up the end of the sear lever retainer (be sure the
extractor has been removed before doing this). When the head of the retainer is clear of
the slide, pry it the rest of the way from the outside of the slide
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
| Page and
Contents © Marstar Canada Inc.
|
