|
CZ
Model 27 Pistol (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the CZ
Model 27 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To strip Model 24 or Model 27, pull
slide back over on empty magazine. Slide will stay open
and relieve tension on barrel retainer (11). Push in
protruding end of takedown cross pin (37), at same time
slide takedown catch (38) down and free of frame.
|
|
|
|
|
|
2.
|
|
After takedown catch assembly has
been removed, pull out magazine as shown and ease slide assembly
off frame. Magazine is difficult to remove because it holds the
slide open, and must be removed against pressure of recoil
spring.
|
|
|
|
|
|
3.
|
|
Barrel is retained by barrel bushing
(1). First step in removing barrel, is to turn bushing about 30
degrees until line on bushing coincides with line on slide (3).
Then bushing can be pulled out of slide and off barrel.
|
|
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
