|
CZ
Model 50 Pistol (steps 4-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the CZ
Model 50 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
Before attempting disassembly of the
lock mechanism, remove the grip screw (15) and grips (14) (27).
Then carefully clamp the receiver (41) in a vise with padded
jaws. Place a thin metal bar against the bottom of the spring
retainer (26), and push on the bar until the retainer is free of
the receiver. then ease the bar back to original position and
remove the hammer spring (25) from the hammer strut (24).
|
|
|
|
|
|
5.
|
|
Continue disassembly of the lock
mechanism by driving out the trigger pin (31) and sear pin (38),
and use a small wrench to remove the nut (40) from the hammer
bolt (19). Then push out the hammer bolt, lift the side plate
(39) from the receiver, and remove the trigger bar (28), trigger
(30), hammer (23), and other lock parts.
|
|
|
|
|
|
6.
|
|
After removing the hammer, push the
safety (16) out to left without rotating. Take care not to lose
the safety plunger (17) and safety spring (18). Reassemble
in reverse. In replacing the hammer bolt nut so not use
excessive force and strip the threads.
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
|
|
