|
Hungarian
P-37 Pistol
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Hungarian
P-37 pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To strip the M37, first step is to
be sure gun is unloaded. Pull slide (2) to rear until slide
stop (38) engages rear notch as shown. Rotate barrel (8) and
pull it out of slide. Then release slide stop, ease slide off
frame, and remove magazine.
|
|
|
|
|
|
2.
|
|
A single pin (3) retains firing pin
in slide and acts as extractor hinge pin. Hold slide in padded
vise as shown and drive pin out., Remove firing pin (7), firing
pin spring (6), extractor (4) and extractor spring (5).
|
|
|
|
|
|
3.
|
|
Only difficult piece to reassemble
is hammer spring (16). A slave pin is employed to retain the
hammer spring (16) and plunger (15). This slave pin is a
short wire or nail that holds assemblies in place until proper
pin is inserted. Correct pun (24) is driven through frame and
knocks out slave pin.
|
|
|
|
|
|
4.
|
|
Disconnector (12) and ejector (11)
are retained by cross pin (27) through frame. Remove pin and
disconnector will drop out; however, ejector must be driven out
as shown. When reinstalling cross pin, be sure it is in slightly
below the surface to prevent retarding slide motion.
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
