|
Luger
P-08 Pistol (steps 4-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Luger
P-08 pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
Grasp knurled knobs of rear toggle
link (13) and pull upward, buckling rear and forward toggle
links (13 & 16) slightly to relieve tension, Press
receiver axle (5) in slightly from right side of receiver with
finger tip. Axle may now be grasped from left side of receiver
and withdrawn. Toggle and breechblock assembly can now be
withdrawn from the rear of receiver.
|
|
|
|
|
|
5.
|
|
Invert toggle and breechblock
assembly and insert a screwdriver blade in slot in firing pin
spring guide (24) in rear of breechblock (17). Press guide in
about 1/16 and turn counterclockwise 1/4 turn and allow firing
pin spring guide and firing pin spring (23) to come out, taking
care not to allow compressed spring to escape. Firing pin (22)
can now be dropped out rear. Extractor, (21) may be removed by
holding thumb over top of breechblock and extractor out
and extractor spring (20) may now be lifted out of its seat.
|
|
|
|
|
|
6.
|
|
The above steps complete normal
field stripping necessary for cleaning and lubrication.
Reassembly is accomplished in reverse order. When replacing
barrel, receiver, and breech assembly on frame, be sure coupling
link (11) suspended from rear end of toggle assembly drops into
its proper place in front of inclined upper arms of recoil lever
(29). The proper relationship of these parts is shown here.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
