|
Luger
P-08 Pistol (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Luger
P-08 pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
Remove magazine and check to be
sure pistol is unloaded. Press muzzle against a hard surface,
moving barrel and receiver assembly back on frame about
1/4" to release tension on recoil spring, then turn
locking bolt (33) to vertical position as shown.
|
|
|
|
|
|
2.
|
|
Lift out trigger plate assembly (35)
from frame, as shown. when reassembling pistol, trigger lever
(37) in trigger plate must fall into its slot in trigger (38)
and small lip at rear of trigger plate must be inserted under
side of frame in recess provided.
|
|
|
|
|
|
3.
|
|
Slide complete barrel, receiver, and
breech assembly forward and out of receiver as shown. During
this operation, note the position of the coupling link (11) with
relation to recoil lever (29) in rear of frame for reference in
reassembly.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
