|
Mauser
HSC Pocket Pistol (steps 4-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Mauser
HSC pocket pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
To replace safety catch , back
firing pin (8) and spring (7) into slide. Lift firing pin tail
as in disassembly. Install safety and push firing pin down
into place. Replace detent part and push extractor in and back
until it seats itself properly in slide.
|
|
|
|
|
|
5.
|
|
When magazine catch pin (27) is
removed, magazine catch (25), hammer strut (23), and spring (24)
come out as an assembly. This assembly can be taken apart by
giving magazine catch a quarter turn. Great care must be taken
when assembling or disassembling these pieces since they are
under heavy spring tension.
|
|
|
|
|
|
6.
|
|
To remove takedown latch (12), hold
frame as shown. Use a screwdriver or block of wood to push down
latch and rotate it clockwise 180 degrees. Care must be taken to
prevent latch from flying out since it is under heavy spring
tension.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
