|
Mauser
HSC Pocket Pistol (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Mauser
HSC pocket pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To take down the HSc, remove
magazine and clear chamber. Pull hammer back to full cock and
put safety catch down over red dot. Hold down notched catch
inside front of trigger guard. At same time pull slide forward
and upward until it is free of frame.
|
|
|
|
|
|
2.
|
|
To remove barrel, hold slide as
shown.. Push chamber end of barrel forward and upward until it
clears bolt face. If barrel is held too tightly in slide, use a
block of wood or magazine floorplate to lever it out.
|
|
|
|
|
|
3.
|
|
The safety catch (9) is held in
place by a detent (5) and spring (4) that also actuate
extractor. To remove firing pin (8) or safety catch, lift end of
fining pin to position shown. Turn safety to a position halfway
between 'on' and 'off' positions and push safety out with a
screwdriver as shown. Remove extractor and detent parts.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
