|
Mauser
C-96 Broomhandle (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Mauser
C-96 broomhandle pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
To remove trigger (10) and
magazine plunger (9), trigger spring (8) must be removed
first. To do this, use a tool with a small hook to lift spring
free of plunger (9). At same time, push it toward butt until
free.
|
|
|
|
|
|
5.
|
|
Care must be take when removing
rocker coupling (22) since it is under heavy spring tension,.
First lower hammer. Hold lock mechanism in a vise and press down
on plunger (11). At same time push rocker coupling (22) through
as shown.
|
|
|
|
|
|
6.
|
|
To reassemble gun, install bolt (3)
and firing pin, etc. Turn barrel extension upside down and drop
locking block (14) over its projection. Cock hammer and press
down on forward end of lock mechanism until the tail of locking
block (14) snaps into rocker coupling (22).
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
