|
Mauser
C-96 Broomhandle (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Mauser
C-96 broomhandle pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
With point of a bullet, press up
magazine plunger (9) and slide floor plate (29) forward.
Remove follower (28) and spring (27). Then cock hammer. Press
up lock frame stop (20) as shown. Pull barrel extension
assembly (1) off rear of receiver (23).
|
|
|
|
|
|
2.
|
|
After barrel extension assembly is
free of frame, pull down on rear of lock mechanism frame, (19)
to free it from barrel extension. Remove locking block (14).
Handle lock work carefully to prevent frame stop (20) and sear
(16) dropping out of place.
|
|
|
|
|
|
3.
|
|
To remove firing pin (6), use a
small screwdriver to push in firing pin as far as it will go and
give it a 1/4 turn clockwise. Remove pin and push bolt stop (4)
forward and out to right. Recoil spring (7) can now be removed.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
