|
Unique
Military and Police Pistol (steps 4-5)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Unique
Military and Police Pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
Unscrew the grip screws (13), and
remove grips (14), (29). Rotate the safety a half turn from
safe position and lift out of frame. Re-insert magazine, hold
hammer (10), pull trigger (33), and ease hammer down. Place
frame in a vise with padded jaws, and drift out magazine catch
pin (21), and remove magazine catch, magazine catch plunger
(19), hammer spring (18). and hammer plunger (17). Drift out
hammer pin (23), and remove hammer with strut.
|
|
|
|
|
|
5.
|
|
Drift out sear pin (24), and remove
sear (11) and sear spring (12). Drift out magazine safety stop
pin (35) and trigger pin (32). Pull trigger bar (27) inside of
frame, and slide disconnector (36) down to remove it. Roll
trigger assembly back and down through magazine well. Trigger
assembly can be disassembled by drifting out trigger bar pin
(30) and magazine safety pin (31) from right to lift. Reassemble
in reverse. Use a drift punch or slave pin to aid insertion of
magazine catch pin. Head of extractor pin is shaped to match
rounded top of slide. Drive this pin with a plastic hammer or
wood block to avoid damaging it. Extractor pin and firing pin
retaining pin must not project from bottom of slide or they will
interfere with slide movement.
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
