|
Ortgies
Pocket Pistol
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Ortgies
pocket pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
Remove magazine (13). Pull slide
(1) back until slide serrations line up approximately with end
of frame as shown. Push in takedown catch (17) and lift end of
slide free of frame. Push slide forward off barrel.
|
|
|
|
|
|
2.
|
(no image available)
|
To remove barrel (24) for cleaning
or repair, grasp barrel (24) and frame (23) as shown. Twist
barrel counter-clockwise until it is at right angles to frame
and lift up.
|
|
|
|
|
|
3.
|
|
To remove grips, insert a
screwdriver into magazine will and push grip latch (12) in
toward back strap. At same time pry or push up back edge of
grips and rotate them free of undercut on front edge of grip.
|
|
|
|
|
|
4.
|
|
Ortgies reassembles easily once
firing pin (7) is held in check. Push firing pin spring (6) and
guide (5) into firing pin until end of guide can be pushed into
its notch in top of slide. Hook slide over barrel, pull it to
rear and downward.
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
