|
Polish Radom P-35 Pistol
(steps 4-6)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Polish
Radom P-35 exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
4.
|
|
To remove the take-down latch (X),
first cock the hammer. Hold the receiver (BB) as shown to
depress the grip safety (L). Pull the take-down latch out
slightly and turn it up as shown. To remove the latch, it may be
necessary to wiggle it or move the safety slightly to free the
pin. When the latch is removed, the grip safety (L) will drop
free.
|
|
|
|
|
|
5.
|
|
The sear (NN) and disconnector
(MM) will drop out when the sear and disconnector pin (Y) is
removed. To reassemble, place the pieces together as shown.
Drop the tail of the disconnector into the hole in the
receiver (BB). If the bearing holes do not line up with the
hole in the receiver, pull the trigger a bit. This will
usually line up the holes.
|
|
|
|
|
|
6.
|
|
The recoil spring on this gun must
be removed as an assembly. To disassembly the recoil spring
group (CC through HH), squeeze the assembly slowly in a
vise until the slotted recoil spring guide (DD) is in as
far as it can go. Now, using a thin punch, push put the spring
guide retainer pin (EE0). It may be necessary to spread the
coils of the spring to remove the pin.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
