|
Polish Radom P-35 Pistol
(steps 1-4)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Polish
Radom P-35 exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
Remove the magazine, draw back the
slide far enough to put on the take-down latch (X). Pull
forward on the exposed end of the recoil spring guide (HH) to
relieve the tension on the slide stop (AA). At the same time,
push out the slide stop. Release the take-down latch and draw
the slide assembly off the front of the receiver. (If pistol
has no take-down latch, retract the slide, depress
hammer-lowering catch, and ease slide forward until catch
engages notch on hammer.)
|
|
|
|
|
|
2.
|
|
To remove the firing pin (E), first
remove the firing pin retainer plate (LL). Due to the split
construction, the retainer plate sometimes gets wedged into the
slide. So, insert a thin-bladed screwdriver as shown. Push in
the firing pin (E) with a thin punch far enough to catch the
shoulder on the pin and hold it out of the bushing, while prying
the retainer plate down and out of the slide.
|
|
|
|
|
|
3.
|
|
To remove the extractor (C), pull
out the recoil spring assembly (CC through HH) and disengage the
barrel (II) from the slide. Remove the firing pin retainer plate
(ll). Using a small screwdriver, press the extractor (C) outward
toward the outside of the slide, pressing rearward at the same
time. Remove the extractor through the rear of the slide.
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
