|
Sauer & Sohn Model 38 Pistol
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Sauer
& Sohn Model 38 pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To disassemble, remove magazine and
clear chamber. Pull down latch (50) in upper portion of trigger
guard. Pull slide (1) to rear and lift it up. Ease slide forward
off barrel.
|
|
|
|
|
|
2.
|
(no image available)
|
To remove breechblock assembly,
drive out retainer pin (8). It must be driven from the right to
left. Breechblock can bow be driven forward out of slide
exposing firing pin (12), extractor (7), and cartridge indicator
(4).
|
|
|
|
|
|
3.
|
(no image available)
|
When reassembling breechblock,
install extractor and indicator pin. Firing pin should be held
in place by a short slave pin which is pushed out when retainer
pin is driven in. This will prevent damage to spring and firing
pin.
|
|
|
|
|
|
|
|
|
|
4.
|
(no image available)
|
To disassembly sear mechanism, bring
hammer back to full cock. Hammer strut (22) will extend through
hole in frame exposing a small cross-drilled hole. Slip a piece
of wire through to hold hammer strut and hammer spring. Sear
mechanism can now be easily removed.
|
|
|
|
|
|
5.
|
(no image available)
|
When trigger bar (17) is
reinstalled, long tail of trigger spring (46) must push up on
pointed pin on trigger bar, To do this, hold spring down with a
thin punch thrust through large hole on left side of frame (29).
|
|
|
|
|
|
6.
|
|
Magazine safety retainer (18) is
staked to frame but sometimes it is necessary to remove it. To
do this, hold gun in a vise and tap out from the inside. It must
be restaked when replaced.
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
| Page and
Contents © Marstar Canada Inc.
|
