|
Steyr
Model 1912 Pistol (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Steyr
Model 1912 pistol exploded parts diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To field strip the pistol, clear
the magazine and chamber. Then depress the serrated end of the
wedge spring, and push the wedge (2) out of the slide (4) and
receiver (30).
|
|
|
|
|
|
2.
|
|
Pull the slide all the way back and
lift it off the receiver. The barrel (10) can then be removed.
In reassembly, the barrel must be positioned so the locking lugs
are to the right.
|
|
|
|
|
|
3.
|
|
For further disassembly, lower the
hammer (8), and remove any dirt from the slotted pin part of the
safety so that it points forward, and use a punch or small
screwdriver to push it to the left out of the receiver. Unscrew
the hammer screw (18), and remove the hammer. Use a screwdriver
to compress the upper rear of the recoil spring retainer (11),
and push the retainer out forward.
|
|
Then remove the recoil spring (13)
and recoil spring caps (12) (14). Slightly depress the ejector
and disconnector (9), and use a small screwdriver to gently pry
out the trigger bar (7). Then lift out the ejector and
disconnector. Turn out the grip and floorplate screw (22), slide
the grips (21) and (31) out of the receiver, and remove the
floorplate (23) with attached spring, and magazine spring (28),
and magazine follower (27). Depress the cartridge release spring
(20), turn it forward a quarter turn, and lift from receiver.
Also remove the trigger pin (16) and removing the trigger (15)
completes disassembly of the receiver group.
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
