|
Walther
P-38 & Walther HP (steps 1-3)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Walther
P-38 exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
Push the safety catch (N) to
safe position. Pull back the slide until the slide stop (KK)
retains it. Remove the magazine. Revolve the barrel retaining
latch (OO) until it stops. Release the slide stop and pull the
slide and barrel assembly forward, off the receiver. Push in
the exposed end of the locking block pin (TT) to separate the
barrel from the slide.
|
|
|
|
|
|
2.
|
|
To check the firing pin (J) and the
indicator pin (H), the cover must be removed. Hold the slide as
shown to prevent the rear sight from falling out. Using a small
screwdriver, push the indicator pin inside the slide and insert
the blade as shown. A simultaneous push upward and forward will
free cover (C) from slide.
|
|
|
|
|
|
3.
|
|
Remove automatic firing pin lock
spring and lock (E and F), firing pin retainer pin (G), and
indicator pin and spring (H and I). Safety catch must be
in fire position before pushing out firing pin. With safety
catch between safe and fire, pry out with screwdriver, as shown.
|
|
|
|
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
|
|
|
|
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
