|
Webley
Mark IV Revolver (steps 1-4)
|
|
WARNING:
Marstar assumes no responsibility for the
accuracy of the enclosed diagrams for purposes of stripping or,
assembly of parts of any firearm. Stripping,
assembly, and reassembly of any firearm or component(s)
thereof should be performed by a competent gunsmith. Marstar
assumes no liability for any modifications, repairs or
alterations performed on any firearm as a result of consulting
theses pages. For reference purposes only.
|
|
|
|
Instructions below refer to part
numbers listed on the Webley
Mk. IV exploded diagram. Please note the reference numbers
therein do not correspond with the part numbers in our online
catalogue.
|
|
STOP!
Always 'clear' and inspect gun to ensure ammunition is not
loaded or chambered before performing maintenance on this or
any firearm.
|
|
|
|
|
1.
|
|
To field-strip the Mark IV,
depress the thumb lever of barrel catch (10), open revolver
fully, and remove any cartridges. Remove cam lever lock screw
(38) with a coin. Rotate cam lever (39) upward and push it
toward barrel (1). Lift cylinder (6) off its axle.
|
|
|
|
|
|
2.
|
|
Place two empty cartridge cases in
opposite chambers of cylinder. Insert a nail through hole in
extractor nut. Remove extractor (7) and extractor spring (3).
This is sufficient stripping for normal cleaning.
|
|
|
|
|
|
3.
|
|
For further disassembly, unscrew
hinge pin screw (46) and push hinge pin (42) out to left. Barrel
and extractor lever (45) can now be removed and separated.
Unscrew the two cylinder cam screws (5) and remove cylinder
retaining cam (4).
|
|
|
|
|
|
4.
|
|
Unscrew grip screw (30) and remove
grips (29), (16). Then, cock the hammer (8). Loop a paper clip
around the mainspring (25), securing the wire by twisting with
pliers. Pull trigger (20), and lower hammer with thumb. Unhook
upper limb of mainspring from hammer swivel (14), and lift out
mainspring. Relieve mainspring tension by pinching limb ends
together with padded pliers and sliding loop of paper clip
toward closed end of spring. Unscrew trigger guard screws (23)
and remove trigger guard (22).
|
| Need
some parts for your pistol? Looking for a quality new or
used handgun? If so, you've come to the right site. Visit
our main pistols page to get
started! |
|
|
|
|
| Page and
Contents © Marstar Canada Inc.
|
